Numerical Study of the Influence of the Primary Stream Pressure on the Performance of the Ejector Refrigeration System Based on Heat Exchanger Modeling
Numerical models of the heat exchangers in ejector refrigeration system (ERS) were developed and validated with the experimental data. The models were based on the switched heat exchangers model using the moving boundary method, which were capable of estimating the zones’ lengths, the outlet temperatures of both sides and the heat loads at various experimental points. The developed models were utilized to investigate the influence of the primary flow pressure on the performance of an R245fa ERS based on its coefficient of performance (COP) and exergy efficiency. It was illustrated numerically and proved experimentally that increasing the primary flow pressure slightly reduces the COP while the exergy efficiency goes through a maximum before decreasing.
Aphornratana S, Chungpaibulpatana S, Srikhirin P. Experimental investigation of an ejector refrigerator: Effect of mixing chamber geometry on system performance. Int J Energy Res 2001; 25:397–411. doi:10.1002/er.689.
 Huang BJ, Jiang CB, Hu FL. Ejector Performance Characteristics and Design Analysis of Jet Refrigeration System. J Eng Gas Turbines Power 1985; 107:792. doi:10.1115/1.3239802.
 I. W. Eames, S. Aphornratana, H. Haider. A theoretical and experimental study of a small scale steam jet refrigerator. Int J Refrig 1995; 18:378–86. doi:10.1016/0140-7007(95)98160-M.
 Thongtip T, Aphornratana S. An experimental analysis of the impact of primary nozzle geometries on the ejector performance used in R141b ejector refrigerator. Appl Therm Eng 2017; 110:89–101. doi:10.1016/j.applthermaleng.2016.08.100.
 Chen W, Shi C, Zhang S, Chen H, Chong D, Yan J. Theoretical analysis of ejector refrigeration system performance under overall modes. Appl Energy 2015:1–11. doi:10.1016/j.apenergy.2016.01.103.
 Kays WM, London AL. Compact Heat Exchangers. 3rd ed. 1997.
 Liu J, Wei W, Ding G, Zhang C, Fukaya M, Wang K, et al. A general steady state mathematical model for fin-and-tube heat exchanger based on graph theory. Int J Refrig 2004; 27:965–73. doi:10.1016/j.ijrefrig.2004.06.008.
 Costa MLM, Parise JAR. A Three-Zone Simulation Model for Air-Cooled Condensers 1993; 13:97–113.
 Ge YT, Cropper R. Performance evaluations of air-cooled condensers using pure and mixture refrigerants by four-section lumped modelling methods. Appl Therm Eng 2005; 25:1549–64. doi:10.1016/j.applthermaleng.2004.10.001.
 Ding G liang. Recent developments in simulation techniques for vapour-compression refrigeration systems. Int J Refrig 2007; 30:1119–33. doi:10.1016/j.ijrefrig.2007.02.001.
 Bejarano G, Alfaya JA, Ortega MG, Vargas M. On the difficulty of globally optimally controlling refrigeration systems. Appl Therm Eng 2017; 111:1143–57. doi:10.1016/j.applthermaleng.2016.10.007.
 Grald EW, MacArthur JW. A moving-boundary formulation for modeling time-dependent two-phase flows. Int J Heat Fluid Flow 1992; 13:266–72.
 Seyfettin Yildiz. Design and Simulation of a Vapor Compression Refrigeration Cycle for a Micro Refrigerator. Middle East Technical University, 2010.
 Admiraal DM, Bullard CW. Heat Transfer in Refrigerator Condensers and Evaporators. vol. 61801. Illinois, Urbana: 1993.
 Gullapalli VS. Estimation of Thermal and Hydraulic Characteristics of Compact Brazed Plate Heat Exchangers. Lund University, 2013.
 Hamzaoui M, Nesreddine H, Aidoun Z, Balistrou M. Experimental study of a low grade heat driven ejector cooling system using the working fluid R245fa. Int J Refrig 2018; 86:388–400. doi:10.1016/j.ijrefrig.2017.11.018.
 Eldakamawy MH, Sorin M V, Brouillette M. Energy and exergy investigation of ejector refrigeration systems using retrograde refrigerants. Int J Refrig 2017; 78:176–92. doi:10.1016/j.ijrefrig.2017.02.031.